Toshiba kV-9960A 사용자 설명서
RECORDING
OPERATION
PREPARATION
INTRODUCTION
PLAYBACK
OPERATION
NOTICE
A Word on the Exclusive 3N-100AAS
Battery Pack
Battery Pack
The nickel-cadmium battery pack (3N-100AAS) is used for
power source of the built-in clock and memory circuit.
power source of the built-in clock and memory circuit.
Charging the Battery Pack
1. Turn on the power of the VCR.
2. The battery pack in the VCR is charged.
2. The battery pack in the VCR is charged.
Battery Installation
Removal:
1. Remove the battery cover.
2. Disconnect the connector in the VCR.
1. Remove the battery cover.
2. Disconnect the connector in the VCR.
Specification of Battery
i
Temperature
For charging
For charging
:
0°C to 80°C
For operating
:
–20°C to 80°C
For storing
:
–30°C to 80°C
i
Charging time
:
more than 48 hours
Notes:
i
Use only for this VCR.
i
Do not dispose of the batteries into fire.
i
Do not short circuit the terminals.
i
Do not modify or disassemble.
i
Avoid dropping, unnecessary shocks.
8
Connector
RED wire
Battery pack
Installation:
1. Install the battery pack placing the red wire upside, and
1. Install the battery pack placing the red wire upside, and
connect the connector on the battery pack to this VCR.
Make sure the polarities (+) and (–) are correct.
Make sure the polarities (+) and (–) are correct.
2. Close the battery cover.
Note:
If the Battery Pack is removed, the memory data will be
erased. In such a case, perform the setting from the first step.
erased. In such a case, perform the setting from the first step.