JVC HR-S8965EK 사용자 설명서

advanced features

set input mode

Press AUX and/or PR so that F-1 for the VIDEO/AUDIO input connectors or

S-1 for S-VIDEO/AUDIO input connectors appears in place of a channel number.

loc ate end point

Load the recording cassette into your VCR, and play it back to determine the

edit-out point (the end of the segment to be replaced) using the JOG dial or pressing

and |.

reset counter

Press 0000 to change the counter display to ‘0:00:00’.

loc ate start point

Determine the edit-in point (the bginning of the segment to be replaced)

using the JOG dial or pressing

and |.

• Be sure to engage the Still mode at the edit-in point.

engage insert editing

Press INSERT.

• Your VCR enters the Insert-Pause mode. (‘U’, ‘ d’ and ‘ ’ light up on the display panel.)
• The TV screen changes from the still picture to the input source you are going to record.

start editing

Load the source cassette and playback the segment that is to be inserted. When

you reach the start of the section of the source tape that you wish to insert, press . to start the
tape in ypur VCR; Insert Editing begins at this point.
• ‘U’ and ‘ d’ are displayed on the front display panel.

end insert editing

At counter ‘0:00:00’, Insert Editing will stop automatically while the tape

continues running in the Play mode. If you wish to stop Insert Editing before the specified edit-
out point, press 0000.

For AV Insert Editing

If you want to replace the picture, Hi-Fi audio soundtrack and normal audio soundtrack all at the
same time...
... In the procedures above, after you prees INSERT, press A.DUB also. (‘U’ and ‘ d’ blink and
‘ ’ lights up on the display panel.)

NOTES

• All necessary cables can be obtained from your dealer.
• Insert Editing is not possible with cassettes whose safety tab has been removed.
• When Insert Editing is performed on a tape that has been recorded on another VCR, the

inserted portion portion may appear distorted.

• In Insert Editing, the recording speed (SP/LP) is determined by the previous recording to be

replaced. If the previous recording’s speed changes within a single edit, the inserted picture will
be distorted at the switching point.

• A small portion of the recording which precedes an insert edit may become crased.
• Insert Editing is also possible using the rear panel AV1 (L-1)IN/OUT or AV2 (L-2) IN/DECODER

connector. When using these connectors, make sure to select the correct input mode in the
procedures adove.

HR-S8965EK-EN/p55-63

4/19/03, 01:04 PM