JVC HR-S6965EK 사용자 설명서

advanced features

  Enter the details of the programme into your satellite

receiver (see receiver manual) and put a tape in the VCR.

  Press 

/

 on the Remote Control to set the tape speed to either 

SP

 or 

LP

.

  Press and hold 

SAT

c

 (|)on the VCR for about 2 seconds. The

SAT

c

 indicator on the VCR display panel lights up and the VCR turns off automatically. Any

signal detected at the 

L-2 IN/DECODER

 connecter will automatically start the VCR recording;

when the signal stops, so will the VCR.

Notes

  Auto Satellite Prog Recording is only possible using the 

L-2 IN/DECODER

 connec-

tor.

  You cannot put the VCR into 

TIMER MODE

 when using Auto Satellite Prog

Recording Mode.

r

  The number of programmes recorded will not be displayed on the VCR display

panel when the r button is pressed.

  Auto Satellite Prog Recording is not possible if your satellite receiver does

not have a timer.

  The 

SAT

c

 indicator light flashes when Auto Satellite Prog Recording is in progress.

  To disengage the VCR during Auto Satellite Prog Recording, press the o button.

The VCR will stop recording and turns off.

  When recording two or more programmes consecutively, you cannot set a different

tape speed for each programme. The first speed selected will apply to all programmes in that
recording session.

  The 

B.E.S.T.

 system will not work during Auto Satellite Prog Recording.

  

Just Clock

 does not work when in Auto Satellite Prog Recording mode.

  The VCR will only react to the start of an incoming signal at the 

L-2 IN/

DECODER

 connecter. If you try to engage Auto Satellite Prog Recording Mode whilst the satellite

receiver is powered on, the 

SAT

c

 indicator light will flash but the VCR will not record. You must

power the satellite receiver off then on again to begin recording in these circumstances.

  You can record in the same way from a cable system as long as you connect the

cable system has a timer on/off function and is connected to the 

L-2 IN/DECODER connector

.

  Some satellite receivers output signals even when turned off. These receiv-

ers cannot be used with this VCR in this way.

  HR-S6965EK-EN/p29-42

2/14/03, 01:54 PM

38