JVC HR-J449MS 사용자 설명서

Your video recorder can automatically play back the whole tape
20 times repeatedly.

START PLAYBACK

Press 4($).

ACTIVATE REPEAT

PLAYBACK

Press 4($) and hold for over 5 seconds, then release.

● The Play indicator ($) on the display panel blinks

slowly.

● The tape plays 20 times automatically, and then

stops.

STOP PLAYBACK

Press 5 at any time to stop playback.

Pressing 4($), 2, 3 or 6 also stops Repeat Playback.

3R(= Resolution and Response Recovery technology) maximises
sense of resolution and sharpens image edges to make playback
picture look better focused.

ACTIVATE 3R PICTURE

Press 3R. The button will light.

● To turn off 3R Picture, press 3R again so that the light

goes off.

● Normally it is recommendable to keep 3R Picture ON

(with the button lit).

● Depending on the type of tape used, picture quality

may be better with 3R Picture set to off.

● If you use this recorder as the player for editing, be

sure to turn off 3R Picture before starting.

● The setting will remain effective even though you

turn on/off the recorder.

Your video recorder is equipped with NTSC circuitry that can
play back NTSC tapes.

LOAD A CASSETTE

Insert a cassette recorded in NTSC.

START PLAYBACK

Press 4($).

● Pressing SYSTEME COULEUR during NTSC playback

displays "NTSC" on the screen for about 5 seconds.

● Some TVs shrink the picture vertically and place

black bars at the top and bottom of the screen. This is
not a malfunction on the part of either the video
recorder or the TV.

● The picture may roll up and down. This can be

corrected using the V-HOLD control found on some
TVs. (This cannot be corrected if the TV does not
have a V-HOLD control.)

● The counter and tape remaining time readings will be

incorrect.

● During search, still, or frame-by-frame playback, the

picture will be distorted, and there may be a loss of
colour.

● Depending on the type of TV, the top and bottom

portions of superimposed displays may be cut off
during NTSC playback.