Jeep 50-0283x-018 SERIES 사용자 설명서

                                                                                                6

PROCEED TO STEP 16. 

 
 
13. Align top holes in VCP mounting bracket (item 7 pg 2) 

with holes in vehicle. See Figure 11. 

14. Insert (2) two well nuts (item 2 pg 2) into top holes 

and  secure using (2) 10-32 x 1" screws (item 3 pg 2) 
and (2) two # 10 washers (item 4 pg 2). See Figure 11. 

15. Secure bracket to vehicle using (4) four # 10 X 1/2" 

screws (item 5 pg 2).  

 

 
16. Remove and discard storage pocket (item 10 

pg 2). Using a razor knife, carefully trim away 
plastic flange to allow for CD player. See 
Figure 12. Make diagonal cuts at the corners 
to make it easier when breaking tabs.  

 
 

 

 

17. Make all necessary wiring connections to VCP. 

Check function of VCP. See operating instructions 
included with components. For further assistance, 
refer to the video system manual for the technical 
support phone number listed for your area. 

18. Align screws in VCP with slots in bracket and slide 

into position. Make sure screws are          
positioned at bottom of slot. See Figure 13 . 
CAUTION: Do not overtighten screws.  

 
 

19. Install housing bottom (item 11 pg 2) and carefully 

fold carpet away from each side to gain access to 
mounting holes. Secure to VCP mounting bracket 
using (2) two # 8 X 9/16" screws (item 6 pg 2) on 
each side.  Make sure contour of housing matches 
floor of vehicle. See Figure 14. Carefully tuck carpet 
behind O.E. plastic panel. 

20. Carefully install housing top (item 9 pg 2) and press 

firmly along bottom edge to secure Velcro tape. 

 

 

 

 

 

FIGURE 11 

FIGURE 14 

FIGURE 12 

FIGURE 13