Honeywell DCP200 사용자 설명서
DCP200 Profile Controller & Recorder - Product Manual
51-52-25-150, Issue 1 – April 2009
Configuration & Use
Page 47
Supervisor Mode
This mode is only available if it has been configured from the PC software. The software is
used to copy up to 50 screens from the Configuration Menus to include in Supervisor Mode.
The purpose of Supervisor Mode is to allow certain users access to a lock code protected
sub-set of the main configuration parameters without providing them with the higher level
Configuration Menu unlock code.
used to copy up to 50 screens from the Configuration Menus to include in Supervisor Mode.
The purpose of Supervisor Mode is to allow certain users access to a lock code protected
sub-set of the main configuration parameters without providing them with the higher level
Configuration Menu unlock code.
Entry into Supervisor Mode
CAUTION:
Adjustments to these parameters should only be performed by personnel
competent and authorised to do so.
competent and authorised to do so.
Supervisor Mode is entered from the Main Menu
Hold down
and press
from to enter the Main Menu.
Press
or
to select Supervisor Mode
Press
to enter the Supervisor Mode.
Note:
Entry into this mode is security-protected by the Supervisor Mode Lock Code. Refer to the
Lock Code View section for more details.
Entry into this mode is security-protected by the Supervisor Mode Lock Code. Refer to the
Lock Code View section for more details.
Navigating in Supervisor Mode
Press
to move forward or
to move backwards through the screens.
Press
or
to change the value as required.
Hold down
and press
to return to the Main Menu
Scrolling “Help Text” is shown at the bottom of the screens to aid navigation.
Table 7. Supervisor Mode Screens
Supervisor Mode:
Supervisor Mode
Unlocking
Unlocking
If Supervisor Mode is configured, enter correct code number to
continue.
continue.
- Supervisor Mode
Screens …
Press to select each parameter in turn. Follow on-screen prompts
to alter the values.
to alter the values.