Invacare 1080556 사용자 설명서

Solara™

Part No. 1080556 Rev. I

TROUBLESHOOTING

Chair

Sluggish

Squeaks

Veers

Turn or

Caster

and

Looseness

Right

Left

Performance Flutter

Rattles

in Chair

SOLUTIONS

Check tires for correct
and equal pressure.

Check for loose nuts
and bolts.

Check that both
casters

contact the

ground at the same time.

SAFETY INSPECTION

MAINTENANCE

MAINTENANCE SAFETY PRECAUTIONS

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attach-
ing hardware is tightened securely - otherwise injury or damage may result.

CAUTION

DO NOT over tighten hardware attaching to the frame. This could cause
damage to the frame tubing.

SUGGESTED MAINTENANCE PROCEDURES

1. Keep quick-release axles free of dirt and lint to ensure positive locking and proper opera-

tion. Refer to ADJUSTING THE QUICK-RELEASE AXLE in PROCEDURE 8 of this manual.

WARNING

DO NOT use WD-40

, 3-in-1 oil

, or other penetrating lubricants on quick-

release axles. Otherwise, binding and/or damage to the wheelchair may occur.

2. Clean quick-release axles once (1) a week with a Teflon

lubricant.

WARNING

DO NOT use the wheelchair unless it has the proper tire pressure (p.s.i.). DO
NOT overinflate the tires. Failure to follow these suggestions may cause the
tire to explode and cause bodily harm.

3. If tires are pneumatic, recommended tire pressures will be listed on the side wall of the tires.
4. Periodically adjust wheel locks in correlation to tire wear. Refer to WHEEL LOCK AD-

JUSTMENT in PROCEDURE 9 of this manual.

5. Make sure that ALL bolts are tight before operating wheelchair.

CAUTION

As with any vehicle, the wheels and tires should be checked periodically for
cracks and wear, and should be replaced.

6. The wheels and tires should be checked periodically for cracks and wear, and should be replaced.
7. Keep tilt slides and roller bearings free of dirt and lint to ensure proper operation of the

tilt mechanism.

SAFETY INSPECTION

PROCEDURE 2