Festool PI574422 사용자 설명서

Supplemental Owner’s Manual 

11

The Domino joiner is intended to be used with a dust extrac-

tion system. Using the machine without dust extraction will 

cause it to clog with wood chips.
When installing a Festool dust extraction hose onto the dust 

port of the machine, it is easiest to insert the hose at an 

angle and then push it on the rest of the way as shown to 

the right.

  Note: If you have a non-Festool vacuum system 

and your vacuum hose does not fit the dust extrac-

tion port, a Festool vacuum hose will fit many other 

brands of vacuums.

Dust 

Port

Vacuum 

Hose

On the front of the fence are 3 pair of stop pins. These are 

used to register the tool against the edge of the workpiece 

or against a previously machined mortise slot, and provide 

rapid and precise placement of the tool on the workpiece.
The distances between the locating pin and the center of 

the mortise slot are 20, 37, and 50 mm. The pins are spring 

loaded, but can also be locked in the retracted position.

20 mm

37 mm

50 mm

To retract a pin, push in on it until it clicks into place. To 

release the pins, press the release button on the side of the 

fence. There is a release button for the left and right sets of 

pins.
The pins are spring-loaded, so it is not necessary to retract 

a pin when not in use. However, retracting unused pins will 

prevent them from pushing your workpiece away from the 

fence.

Stop Pin

Retracted 

Stop Pins

Stop Pin 

Release

The base support bracket stabilizes the joiner when mortis-

ing on the face of a narrow board as shown to the right. The 

base support bracket mounts to the underside of the joiner 

with two thumbscrews. Stand the joiner upright on a flat 

surface when installing the bracket to ensure it is flush with 

the front of the joiner.

Support 

Bracket

Thumbscrews

Support 

Bracket

Narrow 

Workpiece