Festool PI574422 사용자 설명서

Supplemental Owner’s Manual 

17

Using tenoned butt joints is an effective method for con-

structing a cabinet carcase. The tenons provide a strong 

support for each of the horizontal partitions of the cabinet. 

The simplicity of this method is that you use the carcase 

components for aligning the joiner.

Horizontal 

Shelf Piece

Vertical 

Side Piece

1.  Lay the vertical side pieces on your workbench, and draw 

lines across both left and right pieces to indicate where 

the shelves will be located. Note that it is easier to avoid 

mistakes later on by drawing double lines, with one line 

above the shelf and one line below the shelf as shown.

Mark the 

Locations of the 

Finished Shelves

2.  For reference, label the top and bottom face of each 

shelf. This is so your left- and right-hand mortises are 

referenced from the same face of each shelf.

3.  Working with one shelf at a time, lay the shelf on top of 

the side piece so its edge lines up with the outside pencil 

line for that shelf location.

  Note: To help you remember how to position the 

shelves for mortising, simply stand the shelf up verti-

cally between the pencil lines, and then gently tip it 

over so it is laying flat against one pencil line.

Because the mortises are registered from the base of the 

Domino (fixed 15 mm distance), the direction that you 

tip the shelf (either toward the top or toward the bot-

tom) depends on how thick the shelf is. Use the following 

guidelines:

 

►

If the shelf is thick (greater than 30mm), tip it down 

with the top-side facing up. 

 

►

If the shelf is thin (less than 30mm), tip it down with 

the bottom-side facing up.

4.  Clamp the two pieces together to prevent them from 

moving.

5.  With the Domino baseplate resting on the face of the 

side-piece, plunge the joiner into the edge of the shelf. 

Do not use the fence for height positioning.

Bottom

Horizontal 

Shelf Piece

Clamp

Vertical 

Side Piece

6.  With the joiner standing upright and its baseplate against 

the edge of the shelf, plunge downward into the side wall 

of the cabinet (see image below).

7.  Repeat these steps for each of the shelves.
8.  When you repeat this process for the other side wall, 

make sure you keep the same side of the shelf facing up. 

Bottom

Horizontal 

Shelf Piece

Clamp

Vertical 

Side Piece