Troy-Bilt E683F-Horse 사용자 설명서

4. Raise handlebars to one of two height 

settings and tighten the height adjustment 

lever. Also, make sure all other mounting 

hardware is securely tightened.
NOTE:  Fully assembled handlebar 

assembly should appear as shown in 

Figure 2-3.

STEP 3:  Move Tiller Off Shipping 

Platform

1. Set the Depth Regulator Lever 

(A, Figure 2-4) to Travel position. Do 

this by lifting the tiller by the handlebars, 

then pulling straight back on the lever 

and sliding down to the highest notched 

setting.
2. Set the Wheel Speed Lever (B, Figure 

2-4) to Freewheel position. To do this, 

move the lever approximately halfway 

between the Fast and Slow settings while 

you rock the tiller forward and backward 

until the wheels move freely.
3. Lift Handlebars high enough to clear 

tiller tines and pull back firmly to dislodge 

the tiller from the platform wheel wells.

STEP 4:  Connect Wire Harness

1.  Ground green (and red for electric 

start units) wire(s) to engine block, Figure 

2-5A.
2.  Connect the safety wire assembly 

(green and yellow wires), Figure 2-5B.
3. Connect the tiller's main harness con-

nection to the neutral safety switch recep-

tacle, Figure 2-5C.

STEP 5:  Attach Wheels/Tines/

PTO Drive Lever

1. Loosen the bolt  (Figure 2-2) on the 

handlebar base and swing the handlebars 

out to the right side.

2. Remove both sets of nuts, 

star washers, screws, and one 

bushing  

(A, B, C, D, E, F, G, Figure 2-6) 

from the yoke plates (H).  There 

is a bushing inside the short link 

(I).  Be careful not to lose it when 

removing screw (G).
3. Slide the plates at the end 

of the Wheels/Tines/PTO Lever 

over the yoke plates (Figure 2-

9).  To aid in the next step, insert 

a screw temporarily into the 

forward most holes (J, Figure 

2-7) of the yoke plates and the 

lever.
4. Align the rear most holes of 

the yoke plates and the Wheels/

Tines/PTO Lever.  Use long nose pliers to 

hold the bushing (L, Figure 27) in place 

while inserting the screw (K) through the 

lever and yoke plates. Install star washer 

(B, Figure 2-6) and nut (A), then hand 

tighten.
5. Retrieve the clutch pawl spring (Figure 

2-8) from hardware bag.

7