Uniden D1364BK 사용자 설명서

1.  Unpack the handset, battery pack, and battery 

cover. If you need to remove the cover, press in on 

the notch and slide the cover down and off.

2.  Line up the battery connector with the jack inside 

the handset; the connector only fits one way.

3.  Push the connector in until it clicks into place; tug gently on the wires to 

make sure the battery pack is securely connected.

4.  Replace the battery cover and slide it into place.
5.  Use the AC adapter to connect the power jack on the base to a regular 

indoor (120V AC) power outlet.

6.  Place the handset in the base with the display facing forward. If the display 

doesn’t light up, reseat the handset or connect the base to a different outlet. 

# Charge the handset completely (about 15 hours) before using.
Connect the Telephone Cord

1.  Use the telephone cord to connect the 

 jack on the base to a 

standard telephone wall jack. 

# If the display says Check TEL Line, check the connection between the 

2.  If you are mounting the phone on the wall, place the mounting slots (on 

the rear of the base) over the pins on the wall plate; slide the base down to 

lock it into place.

Make a quick test call. Pick up the handset and press 

. (Press 

 

to hang up.)

 

x

If there’s a lot of noise, check for interference (see p. 10).

 

x

If you keep hearing a dial tone, change to pulse dialing (see below).

Your phone uses tone dialing by default. If your phone company uses pulse 

dialing, you need to change your phone’s dial mode.
1.  Press 

 and select Global Setup.

2.  Select Dial Mode then Pulse. You’ll hear a confirmation tone.
To send DTMF tones during a call (e.g., for an automated response system), 

press 

 to temporarily switch to tone dialing. When you hang up, the phone 

automatically returns to pulse dialing.