Uniden D1685 사용자 설명서

1.  Unpack all handsets, 

battery 

packs, and 

battery 

covers. If 

you need to 

remove a 

cover, press 

in on the notch and slide the cover 

down and off.

2.  Line up the battery connector with 

the jack inside the handset; the 

connector only fits one way. 

3.  Push the connector in until it 

clicks into place; tug gently on the 

wires to make sure the battery is 

securely connected.

4.  Replace the battery cover and slide 

it into place.

5.  Use an AC adapter to connect the 

power jack on the base to a regular 

indoor (120V AC) power outlet. 

Connect any chargers the same 

way. 

6.  Place a handset in the base with 

the display facing forward. If the 

display doesn’t light up, reseat the 

handset or connect the base to 

a different outlet. For 2 or more 

handsets, place each handset in a 

charger. 

#

Use the telephone cord to connect 

the 

 jack on the base to a 

standard telephone wall jack.

1.  Pick up the handset and press 

. The handset sounds a dial 

tone, and the display shows 

. 

 

–

If you don't hear a dial tone or 

the display says 

check the connection between 

the base and the phone jack. 

2.  Make a quick test call. (Press 

 to 

hang up.) 

 

–

If you keep hearing a dial tone, 

change to pulse dialing.

 

–

If there’s a lot of noise, check for 

interference (see page 19). 

3.  Test all handsets the same way. If 

you can't get a dial tone, move the 

handset closer to the base. 

Your phone uses tone dialing by 

default. If your phone company uses 

pulse dialing, you need to change 

your phone’s dial mode.
1.  Press 

 and choose 

.

2.  Select 

 then 

. You’ll 

hear a confirmation tone. 

To send DTMF tones during a call 

(e.g., for an automated response 

system), press 

 to temporarily switch 

to tone dialing. When you hang up, 

the phone automatically returns to 

pulse dialing.