Suzuki 990C0-86B40 사용자 설명서
Trouble
Shooting
Harness
Diagram
Trouble
Inspection
Diagnosis
Action
Gauge Sticks
Gauge
Inoperative
Inoperative
A. Backclamp may
be too tight.
be too tight.
A.
1. Slightly loosen nuts
holding backclamp.
Check operation.
holding backclamp.
Check operation.
1.
1. If gauge works and is
not loose in panel,
continue using gauge.
not loose in panel,
continue using gauge.
2. If gauge continues to
stick, replace gauge.
stick, replace gauge.
1.
Switch the
instrument power
supply switch on and
off. As power is
supplied the pointer
should jump slightly.
instrument power
supply switch on and
off. As power is
supplied the pointer
should jump slightly.
Check wires to
check they were
installed on the
correct terminals and
power is actually
supplied to gauge.
check they were
installed on the
correct terminals and
power is actually
supplied to gauge.
2 If pointer jumps
(indicating power
supplied), check for
signal from engine. If
signal exists, replace
tachometer.
supplied), check for
signal from engine. If
signal exists, replace
tachometer.
Is power applied to
gauge?
gauge?
Trouble shooting continued next page.
HN0418 rev A ecr 5609 8/05
Yellow/Red
Yellow/Red
Green/Orange
Green/Orange
Green/Orange
Yellow
Yellow
Black
Black
Black
Gray
Gray
Gray
HN0397 revA ecr 4452 03/2004
Sync Port
Lights
Sync Stbd
Sync Stbd
Ground
+14V
Heat shrink tubing
Yellow
Yellow
Yellow