Precision Power PAR-650 사용자 설명서

●

Built-in remote output with turn-on delay for switching on amps.

●

30V MOSFET switching power supply.

●

Gold-plated RCA input/output jacks.

●

Half-din chassis for ease of installation.

1. Read this manual carefully and in its entirety before installing this

equalizer.

2. Always disconnect the battery or remove the fuses for circuits you

will be working on.

3. Check for clearance of any hazards such as wiring harnesses or

heater core before mounting the equalizer to any panels in the
vehicle.

4. Mount the equalizer in a location that is easy to access and won’t be

distracting to vehicle operation while making adjustments.

5. Route all power wires and audio cables away from sharp metal

edges that can cause shorts to ground and any moving parts that
can tangle the wires such as heater controls or wiper motors.

6. Route all power and signal cables as far as possible from other

vehicle wiring harnesses. Loom when appropriate.

7. It is recommended that the equalizer be grounded directly to the

chassis of the Source 1 head unit. The Source 1 head unit should be
grounded at a chassis point (preferably bare or scraped sheet metal)
other than the factory head unit ground wire or under dash brackets.

8. Use only the supplied machine screws to mount the equalizer or

damage to the circuitry could occur.

T

he PAR-650 five-band parametric equalizer features dual-function control knobs

that extend when needed for adjustments and retract when not in use, allowing
full adjustability with minimum control panel clutter. When the knobs are extended
for adjustment they have an in and out position that allows each knob to control
multiple processor settings.

●

Extend and Retract Knobs - To extend and retract the adjustment

knobs, press and release them into the control panel; they will extend or

2