JVC NX-HD10 사용자 설명서

– 11 –

You can set the clock whether the unit is turned on or in
standby mode.

CLOCK/TIMER.

The day of the week starts flashing in the main display.

SELECT 

¢ or SELECT 4 to select the

SET.

• When you press and hold 

SELECT 

¢ or

SELECT 

4, the day of the week changes

continuously.

SELECT 

¢ or SELECT 4 to adjust the hour,

SET.

• When you press and hold 

SELECT 

¢ or

SELECT 

4, the hour digit changes continuously.

• If you want to correct the hour after pressing 

SET,

press 

CANCEL. The hour digit starts flashing again.

SELECT 

¢ or SELECT 4 to adjust the

SET.

•  When you press and hold 

SELECT 

¢ or

SELECT 

4, the minute digit changes continuously.

“ADJUST OK” appears in the main display, and the
built-in clock starts.

Before operating the unit any further, first set the clock
built in this unit, then some other basic settings.

When you press one of the source selecting buttons—
HDD 

3/8, CD 3/8, TUNER/LINE, the unit automatically

turns on (and starts playback if the source is ready).

To turn on the unit without playing, press
STANDBY/ON

 so that the STANDBY/ON lamp on

the unit lights in green.

• The HDD lamp flashes then lights in blue. The

VOLUME lamp also lights in blue. While the HDD lamp
is flashing, no remote control operations are accepted.
For detailed information on the HDD lamp, see page 30.
(See also “Changing the Display Brightness” on the next
page.)

• The 

 indicator starts flashing if the built-in clock is

not set. (It lights if the clock is already set.)

To turn off the unit (on standby), press
STANDBY/ON

 again so that the STANDBY/ON lamp

lights in red.

If Smart Compression has been turned “ON” (see page
40), it starts working and the STANDBY/ON lamp
flashes in green while Smart Compression is
performed. Then the unit will turn off (on standby).

A little power is always consumed even while the unit is in
standby mode.

To switch off the power supply completely, unplug the
AC power cord from the AC outlet.

DO NOT unplug the AC power cord in the following
cases; otherwise, the data in the HDD may be
damaged:
• While recording or editing.
• While Smart Compression is working.

The clock is reset to “Monday AM12:00” after about a minute,
while the tuner preset stations and other settings will be erased in a
few days.

The hour digit in the main display starts flashing.

The minute digits start flashing.

EN10-16_NX-HD10[J_C]f.pm6

02.6.14, 10:20 PM

11