JVC RV-NB10B 사용자 설명서

다운로드
페이지 78
 
10
 
You can preset up to 30 FM stations and 15 AM (MW/LW) stations.
 
Note:
 
Preset numbers may have been set to factory test 
frequencies prior to shipment. This is not a malfunction. 
You can preset the stations you want into memory as 
follows:
There is a time limit in doing the following steps. If the setting is 
canceled before you finish, start again from step
.
 
 
1. Select a band (either AM or FM) by 
pressing TUNER BAND.
 
 
2. Press 
4
 
 or
 
 
¢
 
 to tune in to a station.
 
 
3. Press SET.
 
 
4. Press the number buttons to select the 
preset number you want.
 
 
5. Press SET.
 
“STORED” appears on the display and the station is stored. 
 
 
6. Repeat above steps 
 to 
 for each 
station you want to store into memory with 
a preset number.
 
To change the preset stations,
 
 repeat the same steps as 
above to overwrite a new station.
 
CAUTION: To prevent the preset stations from 
being erased because of a power failure, etc., 
install memory backup batteries in the system. 
(See pages 5 and 6.)
 
■■
 
Playing back discs
 
This system has been designed to play back the following discs—
CD, finalized CD-R/CD-RW (recorded in audio CD format) and 
CD-R/CD-RW (in MP3 format).
• This system is not compatible with the other discs such as DVD, 
DVD-R, and DVD-RW.
 
Notes on MP3:
 
• The system can only recognize files (tracks) with “MP3” or 
“mp3” as the extensions, which can be in any combination of 
upper and lower case.
• It is recommended that you record your material at a 44.1 kHz 
sampling rate, using the 128 kbps data transfer rate.
• You can play back the discs containing the tracks in music CD 
format or MP3 files in ISO 9660 format.
• Some MP3 tracks or discs may not be played back because of 
their characteristics or recording conditions.
• MP3 discs require a longer readout time than normal discs.
• This system recognizes up to 999 tracks on a disc (or less 
depending on the recording condition of a disc).
 
 
1. Turn the LOCK/RELEASE knob 
counterclockwise to open the disc 
compartment door.
 
 
2. Place a disc, with its label side up as 
shown above.
 
 
3. Close the disc compartment door and turn 
the knob to “LOCK” position.
 
To remove the disc,
 
 open the disc compartment door in stop 
mode.
 
 
You can place an 8 cm disc without an adapter.
 
 
If the disc cannot be read correctly (because it is scratched, for 
example), “NO PLAY” or “NO DISC” appears on the display.
 
 
You can place a disc while listening to the other source.
 
Presetting stations
 
Using the remote control only
LOCK/RELEASE knob
CD 
6
¢
7
4
7
4
¢
Number buttons
REPEAT
CD 
6
PLAY MODE
GROUP UP
GROUP DOWN
CANCEL
Group with its play order
MP3 track with its play order
 
Setting a disc
RV-NB10[B].book Page 10 Friday, January 20, 2006 7:58 PM