Exabyte 480 사용자 설명서
Hardware Installation
Installation and Operation
43
Step 9 – Connect the pow er cord
➤
Important
The pow er cord shipped with the
library is a 120 VAC three-conductor power cord
for use in the United States or Canada. If you are
planning to use another input voltage or if you plan
to use the library outside of the U.S. or Canada, you
must supply your own power cord. For more
information, refer to
for use in the United States or Canada. If you are
planning to use another input voltage or if you plan
to use the library outside of the U.S. or Canada, you
must supply your own power cord. For more
information, refer to
.
1.
Make sure that the power switch on the back of the library is
off (the
off (the
0
is pressed
).
2.
Connect the female end of the power cord to the power
connector on the back of the library.
connector on the back of the library.
3.
Plug the male end of the power cord into the power source.
Note:
The library has autoranging voltage selection, so you
do not need to change the voltage setting.
do not need to change the voltage setting.
Step 10 – Pow er on the library
1.
Make sure the library’s door is closed and locked.
2.
Power on the host computer.
Note:
If your host requires that attached peripheral devices
be powered on before the host, power on the library
before powering on the host.
be powered on before the host, power on the library
before powering on the host.
3.
Push the power switch on the back of the library to the on (
I
)
position.