Tyco Electronics P5200 사용자 설명서

111 

 

 

If system selection is programmed to the SYSTEM/CHANNEL Selection knob, direct 

access to systems will not be available. Pressing 

 or 

 will scroll through different 

sets of 16 systems each (banks) if more than 16 systems are programmed into the 
radio. The systems within each bank are then selectable via the SYSTEM/CHANNEL 
Selection knob as described previously in METHOD 1. 

Example of Method 3:  

System: 1 = North 

Group:  1 = Group 1 

 

2 = South 

 

2 = Group 2 

 

3 = East 

 

3 = Group 3 

 

4 = West 

 

4 = Group 4  

1.  Press 

 to the System Select Mode.  

2.  Press 

 to select “West” system. 

3.  Press 

. West is the newly selected system. 

Several methods can be used to select a new channel.  

METHOD 1:  

If channel selection is programmed to the SYSTEM/CHANNEL Selection knob, select 
a channel by turning the SYSTEM/CHANNEL Selection knob to the desired group 
number position. The display registers the new channel name on line two. If the knob is
moved to a position greater than the number of programmed channels, the highest 

programmed channel will remain selected. The 

button can be programmed to 

provide access to a “2

nd 

bank” of 16 channel number positions (17-32). 

METHOD 2:  

(P7270, P7250, and P5250 model radios) From keypad: If channel selection is 

programmed as the primary function of 

 and 

,

 select a channel by pressing 

 or

 to scroll through the channel list. The display registers the new channel name on 

line two.  

1.  Press 

 to toggle scan OFF and verify   is not displayed. 

2.  Select group or channel. 

3.  Press 

 once to remove group or channel from list. 

4.  Press 

 once to add as a normal channel. 

5.  Press 

 twice to add as a Priority 2 channel. 

6.  Press 

 three times to add as a Priority 1 channel. 

7.  Press 

 to re-start scanning.