Sterling SDAP 사용자 설명서

 

(Available online at www.sterlco.com) 

 

 

682.92636.03  

 Street • New Berlin, WI 53151 USA                                                                    Bulletin No: DH1-315.02 

1.  Shut down the dryer, tag out and lock out the controls if 

necessary. 

2.  Shut the water off to the cooling coil. 
3.  Remove the four 10-32 bolts. 
4.  Gently slide the cooling coil out. 
5.  Visually inspect the coil for leaks, dirt, and any sign of 

contaminants. 

6.  Blow the dust out, or if the coil is covered with plasticizer, 

steam clean it. 

7.  Place the coil back in its housing. Make sure the gasket is 

undamaged; replace if necessary. 

8.  Inset the four 10-32 bolts back in place. 
9.  Turn the water to the cooling coil back on. 

 
 
 

 

 
 
 
 
 
 
 

 

 
 
 
 
 
 
 
 

  

1.  Turn off and/or lock out electrical power to the dryer. 
2.  Loosen the clamp, and remove the dust can. 
3.  Remove the thumb nut, on the center retaining rod, to remove the 

filter cartridge. 

4.  Pull the filter cartridge out. 

• 

Try vacuum-cleaning a soiled filter first. Vacuuming removes most 
large particles and surface contaminants, and may suffice for the first 
time you clean a filter.  

• 

Use a commercial-duty (recommended) or household vacuum 
cleaner. Vacuum the filter from the air intake (dirty) side only. 

1.  Blow clean, dry, compressed air up and down the pleats, blowing out 

the filter from the inside out.  

2.  Remove loose dirt from the filter with compressed air or vacuum from 

the outside. 

3.  Inspect the filter element. Briefly hold a light bulb behind the element 

and look for any fatigued paper or residual dirt. Inspect for holes and 
tears by looking though the filter toward a bright light. Check for 
damaged gaskets or dented metal parts.  

Thumb Nut

Clamp

Dust Can

Filter

Cartridge

Filter Housing

Air In

Air Out

Undo (4) 10-32 Button 
Head Screws using 1/8 
Allen Wrench

Use compressed air or a steam 
cleaner to blow the dust off or
clean any oily residue on the coil.

1" Wide x 1/8" Thick High 

Temperature Gasket

Water flow requirement:
    If used as an After-Cooler: 3 to 4 GPM @80°F.
    If used as a Plasticizer Trap: 3 to 4 GPM @ 40°F to 
45°F.

Process 

Heater

Desiccant 

Tanks

Filter

Blower

Valve

T’Couple 

Location

Slide
Gate

ON

O

F

F

Convey to Drying Hopper With 

Proportioning Valve & Two                  

Machines, Configuration “DP” 

Convey to Drying Hopper With 

Proportioning Valve & Two            

Machines, Configuration “CP”