Whirlpool W10164752A 사용자 설명서

Check local codes and consult gas supplier. Check existing gas 
supply, electrical supply and venting, and read “Electrical 
Requirements,” “Gas Supply Requirements” and “Venting 
Requirements” before purchasing parts.

Mobile home installations require special parts (listed following) 
that may be ordered by calling the dealer from whom you 
purchased your dryer. For information on ordering, please refer to 
the “Assistance or Service” section. You may also contact the 
dealer from whom you purchased your dryer.

■

Mobile home installation kit. Ask for Part Number 346764.

■

Metal exhaust system hardware.

■

A location that allows for proper exhaust installation. See 
“Venting Requirements.”

■

A separate 30-amp circuit.

■

A grounded electrical outlet located within 2 ft (61 cm) of 
either side of the dryer. See “Electrical Requirements.”

■

A sturdy floor to support the total weight (dryer and load) of 
200 lbs (90.7 kg). The combined weight of a companion 
appliance should also be considered.

■

Cold water faucets located within 4 ft (1.2 m) of the water fill 
valves, and water pressure of 20-100 psi (

138-690 kPa). You 

may use the water supply for your washer using the “Y” 
connector and short hose (if needed) which are provided.

■

20-100 psi (138-690 kPa) for best performance.

■

A level floor with a maximum slope of 1" (2.5 cm) under entire 
dryer.

Do not operate your dryer at temperatures below 45ºF (7ºC). At 
lower temperatures, the dryer might not shut off at the end of an 
automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will 
be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit, 
installation of the dryer in garages, closets, mobile homes or 
sleeping quarters. Contact your local building inspector.

NOTE: No other fuel-burning appliance can be installed in the 
same closet as a dryer.

The location must be large enough to allow the dryer door to 
open fully. 

*Most installations require a minimum 5" (12.7 cm) clearance 

behind the dryer for the exhaust vent with elbow. See “Venting 
Requirements.”

The following spacing dimensions are recommended for this 
dryer. This dryer has been tested for spacing of 0" (0 cm) 
clearance on the sides and rear. Recommended spacing should 
be considered for the following reasons:

■

Additional spacing should be considered for ease of 
installation and servicing.

■

Additional clearances might be required for wall, door and 
floor moldings.

■

Additional spacing should be considered on all sides of the 
dryer to reduce noise transfer.

■

For closet installation, with a door, minimum ventilation 
openings in the top and bottom of the door are required. 
Louvered doors with equivalent ventilation openings are 
acceptable.

■

Companion appliance spacing should also be considered. 

■

Additional spacing is required if you exhaust out the rear of 
the dryer to either the right or left side.

*Required spacing

This dryer is suitable for mobile home installations. The 
installation must conform to the Manufactured Home 
Construction and Safety Standard, Title 24 CFR, Part 3280 
(formerly the Federal Standard for Mobile Home Construction 
and Safety, Title 24, HUD Part 280) or Standard CAN/CSA-Z240 
MH.

A

B

C