Maytag W10388780A 사용자 매뉴얼

다운로드
페이지 40
11
Non-steam  
model 
ADDITIONAL FEATURES
2.  Align the two hooks on the front of the drying rack with 
the holes in the dryer door opening and press down fully 
into holes. Rest the rear support on the dryer back ledge.  
USING THE DRYING RACK
To obtain a drying rack for your dryer, follow the instructions 
included in your dryer drum. Remove and discard any  
packing material before use. 
Use the Drying Rack for items that you do not want to 
tumble dry, such as sweaters and tennis shoes. When you 
use the drying rack, the drum continues to turn, but the rack 
remains stationary. 
The drying rack is intended for use with the Timed Dry 
cycles only. The drying rack cannot be used with  
Sensor cycles.
To use the drying rack: 
IMPORTANT: Do not remove the lint screen. 
1.  Open dryer door. 
3.  Place wet items on top of the drying rack. Allow space 
around items for air to circulate. The drying rack does 
not move, but the drum will rotate; be sure to leave 
adequate clearance between items and the inside of 
the dryer drum. Make sure items do not hang over the 
edges or between drying rack grille. 
4.  Close the door. 
5.  Select a Timed Dry/Air Only, or Low Temperature cycle. 
Items containing foam, rubber, or plastic must be dried 
on a clothesline or by using the Air Only setting. 
6.  When the cycle is selected, the Estimated Time  
Remaining display shows the default time. You can 
change the actual time in the cycle by increasing or 
decreasing the cycle time. 
7.  Start the dryer. 
NOTE: Check the lint screen and remove any lint  
accumulated from items dried on the drying rack  
after the cycle is finished. 
3.  Turn bulb counterclockwise. Replace the bulb with  
a 10-watt appliance bulb only. Replace the cover and 
secure with the screw. 
4.  Plug in dryer or reconnect power. 
CHANGING THE DRUM LIGHT
The dryer light automatically turns on inside the dryer drum 
when you open the door. 
To change the drum light: 
1.  Unplug dryer or disconnect power. 
2.  Open the dryer door. Locate the light bulb cover on the 
back wall of the dryer. Remove the screw located in the 
lower right corner of the cover. Remove the cover.