Electrolux 137018200 A 사용자 설명서

Installation Instructions

Turn off power supply to outlet. 

1. 

Remove the screw securing the terminal block 

2. 

access cover in the lower corner on the back of 
the dryer.

Install a UL-approved strain relief according 

3. 

to the power cord/strain relief manufacturer’s 
instructions in the power cord entry hole below 
the access panel. At this time, the strain relief 
should be loosely in place.

Thread an UNPLUGGED, UL-approved, 30 amp.

4. 

power cord, NEMA 10-30 type SRDT, through the
strain relief.

Attach the power cord neutral (center wire)

5. 

conductor to the SILVER colored center 
terminal on the terminal block. Tighten the 
screw securely.

Attach the remaining two power cord outer 

6. 

conductors to the outer, BRASS colored
terminals on the terminal block. Tighten both 
screws securely.

       WARNING

ELECTRICAL SHOCK HAZARD

Do not make a sharp bend or crimp wiring/   

                          

conductor at connections.

3-wire receptacle

(NEMA type 10-30R)

Internal ground

(GREEN screw)

Install

UL-approved

strain relief here

Terminal screw

recovery slot

Line 1

(BRASS terminal)

Neutral

(SILVER terminal)

Line 2

(BRASS terminal)

Access cover

screw

Terminal

block

Neutral

(center wire)

30 AMP

NEMA 10-30

       NOTE

If a terminal screw falls during cord installation, 
it can be retrieved in the terminal screw recovery 
slot below the access panel.

       WARNING

ELECTRICAL SHOCK HAZARD

Failure to disconnect power source before servicing 
could result in personal injury or even death.

Follow manufacturer’s guidelines for firmly 

7. 

securing the strain relief and power cord. 

Reinstall the terminal block cover.

8. 

DO NOT remove

internal ground in

a 3-wire system!!

Neutral

terminal

IMPORTANT

If moving dryer from a 4-wire system and 
installing it in a 3-wire system, move the internal 
ground from the center terminal back to the 
GREEN screw next to the terminal block.