Sony UP-DF500 사용자 설명서

O

per

at

ion

Loading Film

12

Cut the blank part of the bag from the wedges on 
the bag.

Remove the seal after loading the film in the film 
tray. If you remove it before loading, the film may 
slip and drop.

 

Hold the aluminum damp-proof bag with both 
hands so that the opened side faces toward the inner 
side of the tray and place the film in the film tray so 
that the printing surface faces down, with the 
printing surface protection sheet on the bottom.

• When handling the film, do not touch the printing 

surface of the film. Dust, finger prints, or sweat 
are likely to cause unsatisfactory printing.

• Load the film so that it lays flat in the film tray. If 

the film is curled, it will overflow the film tray 
and the printing position may shift. Also, it may 
cause film jamming.

• If you place the film in the film tray with its 

printing surface facing up, it is recommended that 
you clean the thermal head with the cleaning kit 
(supplied). See “To clean the thermal head, platen 

Seal used to grasp the film sheets

Place the film with the printing surface facing down and 
the printing surface protection sheet on the bottom.

Film tray

An IC tag is attached to the printing surface protection 
sheet. Be careful not to damage the IC tag or give it a 
shock.

Face the cut part toward the inner side of the film tray.