JVC LYT1325-001A 지침 매뉴얼

MasterPage: Left

This camcorder’s 2-way power supply system lets you 
choose the most appropriate source of power. Do not use 
provided power supply units with other equipment.

Set the Power Switch to “OFF”.

With the arrow on the battery pack pointing upward, 

push the battery pack slightly against the battery pack 
mount 

a.

Slide up the battery pack until it locks in place 

b.

Connect the AC Adapter to the camcorder, then 

connect the Power Cord to the AC Adapter.

Plug the Power Cord into an AC outlet. The POWER/

CHARGE lamp on the camcorder blinks to indicate 
charging has started.

When the POWER/CHARGE lamp goes out, charging 

is finished. Unplug the Power Cord from the AC outlet. 
Disconnect the AC Adapter from the camcorder.

Slide the battery pack down slightly while sliding BATT. 
RELEASE to detach it. 

* Provided

● It is recommended that only genuine JVC batteries are 

used in this camcorder. Using generic non-JVC batteries 
can cause damage to the internal charging circuitry.

● If the protective cap is attached to the battery pack, remove 

it first.

● During charging, the camcorder cannot be operated.

● Charging is not possible if the wrong type of battery is used.

● When charging the battery pack for the first time or after a 

long storage period, the POWER/CHARGE lamp may not 
light. In this case, remove the battery pack from the 
camcorder, then try charging again.

● If the battery operation time remains extremely short even 

after having been fully charged, the battery is worn out and 
needs to be replaced. Please purchase a new one.

● Since the AC Adapter processes electricity internally, it 

becomes warm during use. Be sure to use it only in well-
ventilated areas.

● Using the optional AA-V40 AC Power Adapter/Charger, you 

can charge the BN-V408U/V416U/V428U/V438U battery 
pack without the camcorder. However, it cannot be used as 
an AC Adapter.

● After 5 minutes has elapsed in Record-Standby mode with the 

cassette inserted, the camcorder will automatically turn off its 
power supplied from the AC adapter. In this case, the battery 
charge starts if the battery is attached to the camcorder.

Perform steps 

2 – 3 in “Charging The Battery Pack”.

* Provided

● Recording time is reduced significantly under the following 

conditions: 
• Zoom or Record-Standby mode is engaged repeatedly.
• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.

● Before extended use, it is recommended that you prepare 

enough battery packs to cover 3 times the planned 
shooting time.

Before detaching the power source, make sure that the 
camcorder’s power is turned off. Failure to do so can result in 
a camcorder malfunction.

Battery pack

Charging time

BN-V408U*

Approx. 1 hr. 30 min.

BN-V416U

Approx. 3 hr.

BN-V428U

Approx. 5 hr.

BN-V438U

Approx. 6 hr. 30 min.

Battery pack

LCD monitor on 

Viewfinder on

BN-V408U*

1 hr.

1 hr. 10 min.

BN-V416U

1 hr. 55 min.

2 hr. 15 min.

BN-V428U

3 hr. 20 min.

3 hr. 55 min.

BN-V438U

4 hr. 35 min.

5 hr. 20 min.

GR-DZ9_DZ7PAL_04Start.fm  Page 12  Wednesday, June 2, 2004  5:22 PM