JVC GZ-MG57AG/AH/AS 사용자 설명서

Settings ([  ]

 = 

Factory-preset

)

墌

Press 4

9

 and then select sub menus.

–

Returns all the camera settings 
to their default values.

EXECUTE: Performs this function.
[CANCEL]: Returns to the menu screen without 

executing reset.

–

Introduces special features of 
the camera at the following 
cases.

● When the menu screen is 

closed.

● When there is no operation for 

about 3 minutes after the power 
switch is set to 

.

OFF: Disables the function.
[ON]: Activates the function.

● The demonstration only works when the DC cord is 

connected, not with the battery.

● If an SD card is in the camera, demonstration will not 

take place even if this mode is set to [ON].

–

Enables you to set the operation 
sound or turn the operation 
sound on/off.

OFF: Turns off the operation sound.
BEEP: The beep sounds when the power is turned on 

or off, and at the beginning and end of recording.

[MELODY]: Instead of a beep, a melody sounds when 

any operation is performed.

–

Turns reception of the operation 
signal from the remote control 
on/off.

OFF: The camera does not receive the signal from the 

remote control.

[ON]: Enables operation with the remote control.

–

Setting this function helps 
prevent damage to the HDD by 
enabling the camera to turn off 
the power automatically when, 
for example, it detects that it has 
been dropped.

OFF: Disables the function.
[ON]: Activates the function.
To turn the unit on when the drop detection worked, 
set the power switch to OFF, and to on again.

Setting this function to off increases the chances of 

damaging the built-in hard disk if the camera is 
accidentally dropped.

–

M6E3Asia.book  Page 55  Thursday, June 1, 2006  4:51 PM