JVC GR-SXM25 사용자 설명서

 EN

Press PLAY, then press ON/OFF on the remote
control. Make sure to point the remote control at the
camcorder’s remote sensor.

•The R.A. Edit counter display appears.

Press REW or FF to locate the beginning of the scene
you want, then press IN/OUT to register that point.

•The data appears under “IN” on the display.

Press REW or FF to locate the end of the scene and
press IN/OUT to register it.

•The data appears under “OUT” on the display.
•The total time of the registered scene(s) is displayed

at the bottom of the screen.

Repeat steps 5 and 6 for each additional scene
(as many as 8).

Press CANCEL during steps 5 and 6 to erase the most
recently registered point.

●

There must be at least one second between an in-point
and its corresponding out-point.

●

To ensure correct operation, there should be at least
15 seconds between an out-point and the next in-point.

●

Blank portions of a tape cannot be registered as in-points
or out-points.

●

If it takes more than 5 minutes to search for an in-point,
the VCR’s Record-Pause mode is cancelled and editing
does not take place.

●

Pressing ON/OFF clears all in- and out-points from
memory.

●

Leave a small margin for error around each in-point to
ensure the scene is recorded in its entirety.

●

Turning off the camcorder’s power erases all registered
in- and out-points.