JVC GY-HM790CHU 사용자 설명서

Audio output from the [PHONES] terminal can be selected 
using [Audio Monitor] in the [A/V Out] menu (A Page 93) as 
well as the [MONITOR SELECT] switch on the camera 
recorder.
The different combinations of settings that are output from 
the [PHONES] terminal and monitor speaker are as follows.

“ Backup recording ” can be performed, which allows the 
same image recorded to the SDHC card on the camera 
recorder to be recorded to the external device connected to 
the IEEE1394 terminal. (A Page 124)

● When connecting the camera recorder to an external 

device using an IEEE1394 cable, make sure to observe 
the following. Improper connection may cause the circuit 
of the connected unit to malfunction.
● Turn off the power of the camera recorder and 

connected devices before connecting the IEEE1394 
cable.

● Do not connect the cable in an environment where 

static electricity occurs or is likely to occur.

● Make sure that each camera recorder is connected to 

only one external device at any one time.

● When the video format input from the [IEEE1394] terminal 

is different from the video format of the camera recorder, a 
AVIDEO FORMAT INCORRECTB message is                     
displayed. Set according to the video format entered for 
[System Definition], [Camera Resolution], and                                 
[Frame & Bit Rate] in the [Record Format] menu. 
(A Page 75)

● If the [INT/EXT] IEEE1394 interface terminal switch is set 

at 

AEXTB and the AHQB mode is selected in                         

[Frame & Bit Rate], signals will not be output from the 

[IEEE1394] terminal. (A Page 75)

[CH-1]

^

CH1

CH1

[BOTH]

[Mix]

CH1+CH2

CH1+CH2

[Stereo]

CH1

CH2

[CH-2]

^

CH2

CH2

[IEEE1394] Terminal

VIDEO FORMAT

INCORRECT