JVC GYHM150U 사용자 설명서
40
Presetting the Time Code/User’s Bit
There are two ways to display the [TC/UB] menu.
A
B
Assign the
ATC/UBB function to a user button and press
the button. (
Setting the time code
1
Use the method above to display the [TC/UB] menu.
2
Set the run mode of the time code generator.
● ARec RunB:The time code operates in the run mode only
during recording.
● AFree RunB:The time code operates in the run mode at all
times.
3
Set the framing mode of the time code generator.
● ANon DropB : The time code generator operates in the
non-drop frame mode. Use this setting when
placing emphasis on the number of frames.
placing emphasis on the number of frames.
● ADropB
: The time code generator operates in the
drop frame mode. Use this setting when
placing emphasis on the recording time.
placing emphasis on the recording time.
Memo :
● ADropB cannot be set when [Record Format]B[Frame &
Bit Rate] in the [Record Set] menu is set to 50, 25, or 24.
4
Select [TC Preset] and press the center of the set
lever.
The time code preset screen appears.
5
Set the time code (hour, minute, second, frame).
● Push the set lever up or down to change the setting value.
● Push the set lever to the left or right to jump to the next digit.
Memo :
● Press the [USER2] button to set all digits to “0”.
6
Confirm the time code setting.
● Press the center of the set lever.
● Returns to the [TC/UB] menu.
Closing the menu screen
1
The normal screen is displayed.
Presetting the user’s bit
1
The method for setting the user’s bit is the same as the
method for setting the time code.
An alphanumeric character between 0 to 9 and A to F can be
specified for each digit.
method for setting the time code.
An alphanumeric character between 0 to 9 and A to F can be
specified for each digit.
Cursor
(During drop frame)
During non-drop frame
MENU/
THUMB
GY-HM150U.book Page 40 Monday, September 5, 2011 1:48 AM