JVC GR-DVP7U 사용자 설명서

Master Page: Right

GR-DVP7U_18-25.fm

Page 21

During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded 
scene on the tape during playback.
If recording starts from a blank portion, the time code begins counting from “00:00:00”
(minute:second:frame). If recording starts from the end of a previously recorded scene, the time code 
continues from the last time code number.
To perform Random Assemble Editing (

墌 pg. 73 – 77), time code is necessary. If during recording a blank 

portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time 
code starts counting up again from “00:00:00”. This means the camcorder may record the same time codes as 
those existing in a previously recorded scene. To prevent this, perform “Recording From The Middle Of A 
Tape” below in the following cases;

● When shooting again after playing back a 

recorded tape.

● When power shuts off during shooting. 

● When a tape is removed and re-inserted during 

shooting.

● When shooting using a partially recorded tape. 

● When shooting on a blank portion located 

partway through the tape.

● When shooting again after shooting a scene then 

opening/closing the cassette holder cover.

1) Play back a tape or use Blank Search (

墌 pg. 23) to find the spot at which you want to start recording, then 

engage the Still Playback mode. (

墌 pg. 22)

2) Set the Power Switch to “A” or “M” while pressing down the Lock Button located on the switch, then start 

recording.

● The time code cannot be reset.

● During fast-forwarding and rewinding, the time code indication does not move smoothly.

● The time code is displayed only when “TIME CODE” is set to “ON”. (墌 pg. 48)

GR-DVP7U_18-25.fm  Page 21  Wednesday, February 27, 2002  5:46 PM