JVC GR-DVX400ED 사용자 설명서

다운로드
페이지 104
EN
 
53
Master Page: Right-Heading0
GR-DVX709SH_37-79.fm
Page 53
FEATURES FOR RECORDING
Makes dark subjects or areas even brighter than they 
would be under good natural lighting. Although the 
recorded image is not grainy, it may look as if it is 
strobing due to the slow shutter speed.
1
Set the Power Switch to “M” while pressing down 
the Lock Button located on the switch.
2
Open the LCD monitor fully or pull out the 
viewfinder fully.
3
Press NIGHT so that the Night-Scope indicator 
”  appears.
● The shutter speed is automatically adjusted to 
provide up to 30 times sensitivity.
● “ ” appears beside “
” while the shutter 
speed is being automatically adjusted.
To deactivate Night-Scope…
Press NIGHT again so that the Night-Scope 
indicator disappears.
NOTES:
● During Night-Scope, the following functions or 
settings cannot be activated and its indicator 
blinks or goes out:
• Some modes of “Program AE With Special 
Effects” (
墌 pg. 42).
• “Snapshot Flash (GR-DVX709/509 only)” 
(
墌 pg. 54).
• “GAIN UP” in CAMERA Menu. (
墌 pg. 45)
• “DIS” in MANUAL Menu. (
墌 pg. 46)
● During Night-Scope, it may be difficult to bring 
the camcorder into focus. To prevent this, use of a 
tripod is recommended.
This feature lets you record still images that look like 
photographs onto a tape.
1
Set the VIDEO/MEMORY Switch to “VIDEO”. 
(GR-DVX709/509 only)
2
Set the Power Switch to “M” while pressing down 
the Lock Button located on the switch.
3
Open the LCD monitor fully, or pull out the 
viewfinder fully.
4
Set “SNAP MODE” to the desired mode. 
(
墌 pg. 38, 45)
5
Press SNAPSHOT.
● The “O” indication appears and a still 
image will be recorded for approx. 6 seconds, 
then the camcorder re-enters the Record-
Standby mode.
● You can perform Snapshot also during 
recording. A still image will be recorded for 
approx. 6 seconds, then the normal recording 
resumes.
● Regardless of the Power Switch position (“A” 
or “M”), Snapshot recording takes place using 
the selected Snapshot mode.
NOTES:
● To remove the shutter sound, refer to “BEEP” on 
page 48.
● If Snapshot recording is not possible, the “O” 
indication blinks when SNAPSHOT is pressed.
● If Program AE with special effects (墌 pg. 42) is 
engaged, certain modes of Program AE with 
special effects are disabled during Snapshot 
recording. In such a case, the icon blinks.
● If SNAPSHOT is pressed when “DIS” is set to 
“ON” (
墌 pg. 46), the Stabiliser will be disabled.
● During playback as well, all snapshot modes are 
available when “
COPY” is set to “OFF” 
in VIDEO Menu. (
墌 pg. 51) However, the shutter 
sound is not heard.
● During Snapshot recording, the image displayed 
in the viewfinder may be partially missing. 
However, there is no effect in the recorded image.
● When a cable is connected to the AV connector, 
the shutter sound is not heard from the speaker, 
however it is recorded onto the tape.
Motor Drive Mode
Keeping SNAPSHOT pressed in step 5 provides an 
effect similar to serial photography. (Interval 
between still images: approx. 1 second)
● The Motor Drive mode is disabled when “REC 
SELECT” is set to “
/
”. (
墌 pg. 38, 50)
Night-Scope
OFF
PLA
Y
A
M
Power Switch
Lock Button
VIDEO/MEMORY 
Switch
(GR-DVX709/509 
only)
MENU Wheel
NIGHT Button
SNAPSHOT Button
Snapshot (For Video Recording)
GR-DVX709SH_37-79.fm  Page 53  Saturday, February 23, 2002  6:06 PM