JVC 0397TOV*UN*YP 사용자 설명서
34
EN
A B
C
IN OUT
ç© 1 0:00:25
2
3
4
5
6
7
8
COUNTER 0:00:25
TOTAL 0:00:00
TOTAL 0:00:00
IN OUT
ç 1 0:00:25 0:01:05
2 0:03:18 0:03:31
3 0:02:33 0:02:53
© 4 0:04:11
5
6
7
8
COUNTER 0:04:11
TOTAL 0:01:13
TOTAL 0:01:13
EDITING
(cont.)
PREPARE CAMCORDER
2
Insert a recorded tape and set the Power switch to
“PLAY”.
“PLAY”.
PREPARE VCR
3
Turn the power on, insert a recordable tape and
engage the AUX mode (refer to VCR’s instructions).
engage the AUX mode (refer to VCR’s instructions).
SELECT SCENES
ACCESS R.A. EDIT COUNTER
DISPLAY
1
Press PLAY/PAUSE, then press R.A. EDIT and the
counter display appears in the viewfinder and the
screen of the connected TV.
counter display appears in the viewfinder and the
screen of the connected TV.
REGISTER BEGINNING OF SCENE
2
Press REW or FF to locate the beginning of a scene
you want, then press IN/OUT to register that point.
The data appears under IN on the display.
you want, then press IN/OUT to register that point.
The data appears under IN on the display.
REGISTER END OF SCENE
3
Press REW or FF to locate the end of the scene and
press IN/OUT to register it. The data appears under
OUT on the display. The total time of the registered
scene(s) is displayed at the bottom of the screen.
press IN/OUT to register it. The data appears under
OUT on the display. The total time of the registered
scene(s) is displayed at the bottom of the screen.
REGISTER ADDITIONAL SCENES
4
Repeat steps 2 and 3 for each additional scene
(as many as 8).
(as many as 8).
MAKE CORRECTIONS
5
Press CANCEL during steps 2 and 3 to erase the
most recently registered point.
most recently registered point.
NOTES:
● There must be at least one second between an in-point
and its corresponding out-point.
● To ensure correct operation, leave at least 15 seconds
open between scenes.
● Blank portions of tape cannot be registered as in-points
or out-points.
● If it takes more than 5 minutes to search for an in-point,
the VCR’s Record-Pause mode is cancelled and editing
doesn’t take place.
doesn’t take place.
● Pressing R.A.EDIT clears all in- and out-points from
memory.
● Leave a small margin for error around each in-point to
ensure the scene is recorded in its entirety.
VCR (Recording deck)
R.A. EDIT
PLAY/PAUSE
PLAY/PAUSE
STOP
REW/FF
CANCEL
IN/OUT
To AUDIO
and VIDEO
out connectors
and VIDEO
out connectors
Audio and
Video cable
(optional)
Video cable
(optional)
To AUDIO
and VIDEO IN
connectors
and VIDEO IN
connectors
Open the cover
To J terminal
(JLIP)
(JLIP)
To
Pause-
In
Pause-
In
To Remote
PAUSE
PAUSE
Editing cable
(optional, 3.5ø
mini-plug cable)
(optional, 3.5ø
mini-plug cable)
RM-V700U
(optional)
(optional)