JVC 0104-FO-ID-PJ 사용자 설명서

MasterPage: Left

● In places subject to low temperature, images become dark 

due to the characteristics of the LCD monitor. When this 
happens, the displayed colors differ from those that are 
actually recorded. This is not a defect of the camcorder.

H Adjust the brightness and angle of the LCD monitor. 

墌 pg. 9, 12)

● When the LCD monitor’s fluorescent light reaches the end 

of its service life, images on the LCD monitor become dark.

H Consult your nearest JVC dealer.

● The LCD monitor and the viewfinder are made with high-

precision technology. However, black spots or bright spots 
of light (red, green or blue) may appear constantly on the 
LCD monitor or the viewfinder during recording or 
playback. These spots are not recorded on the tape. This is 
not due to any defect of the unit. (Effective dots: more than 
99.99 %)

● This may occur when the surface or the edge of the LCD 

monitor is pressed.

● The battery’s charge is low.

H Install a fully charged battery. (

H Push in the memory card a few more times. (

● The viewfinder is pulled out and “PRIORITY” is set to 

“FINDER”.

H Push the viewfinder back in or set “PRIORITY” to “LCD”. 

墌 pg. 12, 25, 27)

● The LCD monitor’s brightness setting is too dark.
H Adjust the brightness of the LCD monitor. (

H If the monitor is tilted upward 180 degrees, open the 

monitor fully. (

● The speaker volume is too great.

H Turn the speaker volume down. (

H Wipe them gently with soft cloth. Wiping strongly can 

cause damage. (

墌 pg. 48) To clean the viewfinder, please 

consult your nearest JVC dealer.

● “TIME CODE” is set to “OFF”.

H Set “TIME CODE” to “ON”. (

墌 pg. 25, 27, 28)

● A malfunction of some kind has occured. In this case the 

camcorder’s functions become unusable.

H

● A malfunction of some kind has occured. In this case the 

camcorder’s functions become unusable.

H

● “REMOTE” is set to “OFF”.

H Set “REMOTE” to “ON”. (

墌 pg. 25, 27)

● The remote control does not point at the remote sensor.

H Point at the remote sensor. (

● The remote control batteries are exhausted.
H Replace the batteries with fresh ones. (

GR-D94US.book  Page 42  Monday, November 17, 2003  2:12 PM