Fujifilm FinePix S5 Pro 사용자 설명서
148
U SET UP
• When the [BCR 1 SHOT] or [BCR CONTINUOUS] is
set, the maximum number of characters or storing
mode (overwrite or add) varies depending on the
[IMAGE COMMENT] setting.
mode (overwrite or add) varies depending on the
[IMAGE COMMENT] setting.
Z Connecting to barcode reader
You can use the barcode reader with a D-sub 9-pin
connector (commercially available).Connect the barcode
reader to the camera using MC-35. See the barcode
reader instruction manual for details.
You can use the barcode reader with a D-sub 9-pin
connector (commercially available).Connect the barcode
reader to the camera using MC-35. See the barcode
reader instruction manual for details.
Barcode reader setting
• Baud rate: 4800 bps
• Data length: 8 bit
• Parity check: –
• Stop bit: 1 bit
• EOF: CR+LF
• Baud rate: 4800 bps
• Data length: 8 bit
• Parity check: –
• Stop bit: 1 bit
• EOF: CR+LF
Z Barcode eraser
Use the barcode reader to read the barcode below to
erase the last barcode information.
Use the barcode reader to read the barcode below to
erase the last barcode information.
Z Using a GPS Unit
Garmin and Magellan GPS units that conform to version
2.01 of the National Marine Electronics Association
NMEA0183 data format can be connected to the
camera’s ten-pin remote terminal using an MC-35 GPS
adapter cord (available separately), allowing information
on the camera’s current position to be recorded when
photographs are taken. Operation has been confirmed
with the following devices:
• Garmin eTrex series equipped with a PC interface cable
Garmin and Magellan GPS units that conform to version
2.01 of the National Marine Electronics Association
NMEA0183 data format can be connected to the
camera’s ten-pin remote terminal using an MC-35 GPS
adapter cord (available separately), allowing information
on the camera’s current position to be recorded when
photographs are taken. Operation has been confirmed
with the following devices:
• Garmin eTrex series equipped with a PC interface cable
connector
• Magellan SporTrak series equipped with a PC interface
cable connector
These devices connect to the MC-35 using a cable with a
D-sub 9-pin connector provided by the manufacturer of
the GPS device. See the MC-35 instruction manual for
details. Before turning the camera on, set the GPS device
to NMEA mode (4800 baud).
D-sub 9-pin connector provided by the manufacturer of
the GPS device. See the MC-35 instruction manual for
details. Before turning the camera on, set the GPS device
to NMEA mode (4800 baud).
CAUTION
• When attaching the GPS device, be sure to turn the
GPS device OFF.
• When attaching the GPS device, if [BARCODE
READER/GPS] is set to [BCR 1 SHOT] or [BCR
CONTINUOUS], the GPS device cannot be connected.
Briefly turn the camera off and set to [GPS].
CONTINUOUS], the GPS device cannot be connected.
Briefly turn the camera off and set to [GPS].
How to use the SET UP menu (
➝p.138)