JVC GR-DV400 사용자 설명서

Master Page: Right

During recording, a time code is recorded on the 
tape. This code is to confirm the location of the 
recorded scene on the tape during playback.
If recording starts from a blank portion, the time 
code begins counting from “00:00:00” 
(minute:second:frame). If recording starts from the 
end of a previously recorded scene, the time code 
continues from the last time code number.
To perform Random Assemble Editing (

61), time code is necessary. If during recording a 

blank portion is left partway through the tape, the 
time code is interrupted. When recording is 
resumed, the time code starts counting up again 
from “00:00:00”. This means the camcorder may 
record the same time codes as those existing in a 
previously recorded scene. To prevent this, perform 
“Recording From The Middle Of A Tape” (

in the following cases;

● When shooting again after playing back a 

recorded tape.

● When power shuts off during shooting. 

● When a tape is removed and re-inserted during 

shooting.

● When shooting using a partially recorded tape. 

● When shooting on a blank portion located 

partway through the tape.

● When shooting again after shooting a scene then 

opening/closing the cassette holder cover.

1) Play back a tape or use Blank Search (

to find the spot at which you want to start 
recording, then engage the Still Playback mode. 
(

2) Set the Power Switch to “A” or “M” while 

pressing down the Lock Button located on the 
switch, then start recording.

● The time code cannot be reset.

● During fast-forwarding and rewinding, the time 

● The time code is displayed only when “TIME 

GR-DV700PAL.book  Page 19  Friday, February 21, 2003  4:04 PM