JVC GR-DX97 GR-DX77 사용자 설명서

MasterPage: Left

● Charging is difficult in places subject to extremely high/low 

temperatures.

H To protect the battery, it is recommended to charge it in 

places with a temperature of 10°C to 35°C (50°F to 95°F). 
(

● The battery pack is not attached firmly.

H Detach the battery pack once again and re-attach it firmly. 

(

墌 pg. 11)

● The built-in clock’s rechargeable lithium battery is 

discharged.

● The previously set date/time is erased.

H Connect the camcorder to an AC outlet using the AC 

Adapter for over 24 hours to charge the clock’s lithium 
battery. (

墌 pg. 12)

● Files stored in the memory card are protected.

H Remove protection from the files stored in the memory 

card and delete them. (

墌 pg. 25)

● This is not a malfunction.

H By recording with “DIS” activated (

墌 pg. 27, 28) this can 

be avoided.

● The DV cable was plugged/unplugged with power turned 

on.

H Turn the camcorder’s power off and on again, then operate 

it. 

● In places subject to low temperature, images become dark 

due to the characteristics of the LCD monitor. This is not a 
malfunction.

H Adjust the brightness and angle of the LCD monitor. 

(

墌 pg. 13, 15)

● When the LCD monitor’s fluorescent light reaches the end 

of its service life, images on the LCD monitor become dark.

H Consult your nearest JVC dealer.

● The LCD monitor and the viewfinder are made with high-

precision technology. However, black spots or bright spots 
of light (red, green or blue) may appear constantly on the 
LCD monitor or the viewfinder. These spots are not 
recorded on the tape. This is not due to any defect of the 
unit. (Effective dots: more than 99.99 %)

● The battery’s charge is low.

H Install a fully charged battery. (

墌 pg. 11)

H Push in the memory card a few more times. (

● The viewfinder is pulled out and “PRIORITY” is set to 

“FINDER”.

H Push the viewfinder back in or set “PRIORITY” to “LCD”. 

墌 pg. 15, 27, 29)

● The LCD monitor’s brightness setting is too dark.

H Adjust the brightness of the LCD monitor. (

H If the monitor is tilted upward 180 degrees, open the 

monitor fully. (

● A malfunction of some kind has occured. In this case the 

camcorder’s functions become unusable.

H

● “REMOTE” is set to “OFF”.

H Set “REMOTE” to “ON”. (

墌 pg. 27, 29)

● The remote control does not point at the remote sensor.

H Point at the remote sensor. (

● The remote control batteries are exhausted.
H Replace the batteries with fresh ones. (

GR-DX97US_08Trouble.fm  Page 46  Friday, April 9, 2004  2:08 PM