VIVOTEK FD6111V 사용자 설명서

 

 

 
 

 
 

 

 

 

 

- 57 - 

 

www.vivotek.com 

T: 886-2-82455282 
F: 886-2-82455532 

 
 

Status LED 
After powering up, the Network Camera performs a self-diagnostic to detect any 
hardware defects. The following table lists the LED patterns in general. In case of any 
fatal error, the LED will blink in a pattern other than those below. 

Condition LED 

Color 

During self-diagnostic after power on  Blinking in interchanged Green and Red 
After power on and before network is 
setup 

Red LED is constantly ON and Green LED is OFF

After network is setup 

Red LED is constantly ON and Green LED 
blinking every 0.5 second 

Ethernet signal is lost 

Red LED is constantly ON and Green LED is OFF

No audio or speak only 

Red  LED  is  constantly  ON  and  Green  LED 
blinking every second 

 

Reset and Restore 
There is a button on the main board of the camera 
inside the dome body as shown in the picture. It is 
used to reset the system or restore the factory 
default settings. Sometimes resetting the system 
sets the system back to normal state. If the 
system problems remain after reset, restore the 
factory settings and install again. 
RESET: Press the button once. 
RESTORE: 1. Press the button continuously. 
2. Plug in the power and wait for the 
self-diagnostic.  
3. Release the button after both LEDs shut off..

Restoring the factory 

defaults will erase any previous 
settings. Reset or restore the 
system after power on.