Panasonic WV-CLR920A 사용자 설명서
-11-
The selected full or half duplex setting will be
enabled after the camera is powered up again.
enabled after the camera is powered up again.
!4 Gen-lock Input Connector (GEN-LOCK)
This connector is used to connect an external sys-
tem for synchronization.
tem for synchronization.
!5 Video Output Connector (VIDEO OUT)
This connector is used to connect with the VIDEO
IN connector of the monitor.
IN connector of the monitor.
!6 RS485 Terminals
(RS485, T(A)/T(B)/R(A)/R(B)/GND)
These terminals are used for RS-485 Camera site
communication. Connect RS-485 cables to these
terminals.
These terminals are used for RS-485 Camera site
communication. Connect RS-485 cables to these
terminals.
!7 Alarm Output Terminal (ALARM OUT/GND)
Connects to the alarm input connector (terminal) of
an external device. When the camera detects
motion, the alarm output signal is supplied to the
connected external device (Open collector output:
16 V DC, 100 mA max).
Note: This signal output is not affected by the alarm
an external device. When the camera detects
motion, the alarm output signal is supplied to the
connected external device (Open collector output:
16 V DC, 100 mA max).
Note: This signal output is not affected by the alarm
data setting in the RS485 setup operations.
(See page 26.)
(See page 26.)
Caution: Connect to 12 V DC (10.8 V-16 V) or 24 V
AC (19.5 V-28 V) class 2 power supply only. Be
sure to connect the grounding lead to the GND
terminal when the power is supplied from a 24 V
AC power source.
sure to connect the grounding lead to the GND
terminal when the power is supplied from a 24 V
AC power source.
!8 Day/Night Input Terminal (DAY/NIGHT IN/GND)
This terminal is used for connecting the camera to
an external day/night detecting sensor.
an external day/night detecting sensor.
!9 AC Inlet Socket
Plug the power cord (supplied as a standard
accessory) into this socket and connect it to an AC
outlet.
accessory) into this socket and connect it to an AC
outlet.
@0 AC/DC Compatible Input Terminal
(DC 12V IN/AC 24V IN, GND)
This terminal is for connecting the 12 V DC or 24 V
AC power supply cord.
This terminal is for connecting the 12 V DC or 24 V
AC power supply cord.
B
1
2
3
!6
!7
!8
4
5
6
7
8
9
T
IN/OUTPUT
TERMINAL
A
B R
A
GND
RS485
ALARM
DAY/
NIGHT
GND
OUT
GND
IN