Nikon S51c 사용자 설명서

다운로드
페이지 191
125
Wireless LAN Settings for the Camera
Wi
re
le
ss Se
rvi
ces
En_01
j
MAC Address Filtering
When MAC address filtering is enabled, only devices with an authorized MAC address can
access the wireless LAN. Check the camera’s MAC address in [Firmware version] of the setup
menu (c 119) and add it to the authorized list.
Sender Information
To use my Picturetown, the sender’s alias (up to 16 alphanumerical charac-
ters) and e-mail address (up to 64 alphanumerical characters; mobile tele-
phone e-mail addresses are not supported) must be configured with the
camera to register user information on the my Picturetown server (c 148).
Once the user information has been registered, user information cannot be
edited from the camera or the Utility.
Picture Mail Recipients
With Picture Mail, e-mail notification can be sent automatically to specified
recipients whenever pictures are uploaded to the server. Up to 30 recipients
can be specified. An alias (up to 16 alphanumerical characters) and e-mail
address (up to 64 alphanumerical characters) must be entered for each recip-
ient. E-mail addresses for only certain models of mobile telephones, used in
Japan and the United States, are supported (c 134). In addition, recipients
can be grouped for specification of multiple recipients as a single Picture Mail
recipient.
Password
A password (four-digit number) can be applied to prevent unauthorized
access to wireless services by third parties and to protect information stored
in the camera.
Encryption key
Enter the encryption key, provided by the network administrator, for the 
selected authentication method. This is not necessary when [Authentication] is 
set to [Open system] and [Encryption] is set to [None].
Key index
When [Encryption] is set to [WEP], select the same key index used by the 
access point (unnecessary when [Encryption] is set to [None], [TKIP], or [AES]). 
The default setting is [1]. Use the Utility to specify a setting other than [1].
Configuration
Select the method for specifying the camera’s IP address from [Auto] (default 
setting) or [Manual].
IP address
When [Configuration] is set to [Manual], enter an IP address, along with a sub-
net mask, gateway, primary DNS, and secondary DNS for the camera.
(mandatory configuration)