Canon EOS1DBODY 사용자 설명서

322

3

 Custom Function Settings

You can enable or disable AF point-linked spot metering in the <r> 

metering mode.

Regardless of the AF point currently selected, spot metering will always 
be linked to the viewfinder’s center AF point.

Spot metering will be linked to the manually-selected AF point. If the AF area 
selection mode is set to 61-point automatic selection or Zone AF (automatic 
Zone selection), spot metering is performed at the viewfinder center.

This function takes effect in the shutter-priority AE (s) and aperture-priority AE 

(f) modes. If the subject’s brightness changes and the standard exposure 

cannot be obtained within the autoexposure range, the camera will automatically 
change the manually-selected setting to obtain a standard exposure.

This function takes effect in the Program AE (d), shutter-priority AE 

(s), and aperture-priority AE (f) modes. If the subject’s brightness 

changes and the standard exposure cannot be obtained within the 
autoexposure range, the camera will automatically change the manually 
set ISO speed to obtain a standard exposure.

If the safety shift automatically sets ISO 32000 or higher (when the camera’s 
internal temperature is low, ISO 20000 or higher), when [ISO speed] is set, the 
maximum continuous shooting speed at <o> will be approx. 10 shots/sec.

 

Under [z2: ISO speed settings], even if [ISO speed range] or [Min. 
shutter spd.] is changed from the default setting, safety shift will 
override it if a standard exposure cannot be obtained.

 

The minimum and maximum sensitivities of the safety shift using the ISO 
speed will be determined by the [Auto ISO range] setting (p.127). 
However, if the manually set ISO speed exceeds the [Auto ISO range], 
the safety shift will extend up to the manually set ISO speed.

 

If [Shutter speed/Aperture] or [ISO speed] is set, safety shift will take 
effect if necessary even when flash is used.

COP

Y