Canon RE-450X 지침 매뉴얼
10
E
VIDEO
OUT
S VIDEO
OUT
RGB OUT
RGB IN
AC INLET
RS-232C
To connect the RE-450X to a liquid-crystal projector, use the RGB cable included in the package. Use the
power cable included in the package.
power cable included in the package.
Connection
To protect the RE-450X as well as other equipment in use, make sure all the
equipment (if any) is OFF before connecting cables. Always hold onto the plug
section whenever connecting/disconnecting the cables.
equipment (if any) is OFF before connecting cables. Always hold onto the plug
section whenever connecting/disconnecting the cables.
See page 15 for connecting various equipment. For details of operation, refer to
the instruction manual of the equipment to be used.
the instruction manual of the equipment to be used.
Liquid-crystal projector
To RGB OUT
RGB cable
To RGB input terminal
Power cord
To AC
power outlet
Rear panel
NOTICE
NTSC
■ Installation Site and Environment
■ Installation Site and Environment
1. Connect the RE-450X to a correct
electronic source.
Source voltage: 120VAC ± 10%
Source frequency: 60 Hz
Source voltage: 120VAC ± 10%
Source frequency: 60 Hz
2. Install the RE-450X in a proper
environment.
Temperature: 41°F – 95° F (5°C –35°C)
Humidity: 85% max (without condensation)
Temperature: 41°F – 95° F (5°C –35°C)
Humidity: 85% max (without condensation)
PAL
■ Installation Site and Environment
■ Installation Site and Environment
1. Connect the RE-450X to a correct
electronic source.
Source voltage: 220 – 240VAC ± 10%
Source frequency: 50 Hz
Source voltage: 220 – 240VAC ± 10%
Source frequency: 50 Hz
2. Install the RE-450X in a proper
environment.
Temperature: 5°C –35°C (41°F – 95° F)
Humidity: 85% max (without condensation)
Temperature: 5°C –35°C (41°F – 95° F)
Humidity: 85% max (without condensation)
RE-450X_E 01.10.24 22:15 ページ 10