Zebra Technologies TTP 2000 사용자 설명서
Page setup
Parameters Used
Parameters Used
106
P1002902-002
TTP 2000 Technical Manual
09/14/2009
Parameter n41 and n42 — Black Mark Cut Offset
After the black mark is detected (black to white change) the printer feeds another distance to
place the paper in cut position. This distance cannot be negative so placing the black mark too
close to the paper edge is better than too far away.
place the paper in cut position. This distance cannot be negative so placing the black mark too
close to the paper edge is better than too far away.
Auto Cut-Offset
If the offset is set to 0, the printer will measure the length of the black mark and add a cut
offset that makes it cut in the middle of the black mark.
offset that makes it cut in the middle of the black mark.
Note •
Auto offset was added in firmware version 3.30.
n41 & n42
=0
C
ut position
Black mark detected