Zebra Technologies TTP 2100 사용자 설명서
11/04/2009
TTP 2100 Operator Guide
P1021708-001
3
Installation
Installing a Paper Guide
The TTP 2100 printers are delivered without paper guide fitted.
1.
Open the printhead by pushing the green printhead open lever backwards and lifting up
the printhead. See
the printhead. See
.
2.
Insert the T-shaped tabs of the paper guide into the “T”-holes, and press the rear of the
guide down and in.
guide down and in.
3.
Fasten the nut using the 5 mm wrench supplied.
4.
Close the printhead.
Figure 4 • Fitting the Paper Guide
When a guide is fitted, make an auto calibration with the ticket media that you are going to
use in the printer. Most ticket medias auto calibrate perfectly, and the printer is ready to
use. Should auto calibration fail on your media, set up paper width parameter n48, and
sensor selected parameter n63 to reflect your media. Then redo the auto calibration.
use in the printer. Most ticket medias auto calibrate perfectly, and the printer is ready to
use. Should auto calibration fail on your media, set up paper width parameter n48, and
sensor selected parameter n63 to reflect your media. Then redo the auto calibration.
5.
Start the utility program Zebra Toolbox. This application is available from
6.
Select Tools | Parameter Settings.
S c re w
N u t
P rim a ry in p u t g u id e
T -ta b s