Fujitsu P3PC-E807-01ENC2 사용자 설명서

 

 

103

• The [Scan] button is pressed, but scanning is not performed.  

Cause: 

Has the scanner power been turned on?  Has the SCSI cable been 
connected correctly?  Has the correct device type been selected using 
[Select TWAIN Input Device]? 

 

• The scanner appears to be operating, but no image is displayed.  

Cause: 

Has the SCSI cable between the scanner and the main unit been 
connected correctly? 

Is the [Brightness] value or [Threshold] value too small?  

When the [Minimize] button is pressed, is the [Restore] button 
displayed?  

Is the application set to perform only file output? 

User response: 

If the [Restore] button is displayed after the [Minimize] button is 
pressed, the problem could be the display driver that is being used.  
Contact the manufacturer of the display driver. 

If a file has been selected as output destination with the environment 
settings by the image scanner operation confirmation utility, try to 
change to screen output. 

 

• When you don’t know how to replace consumables. 

User response: 

Refer to section 6.6 “Device Setup Tab Folder”- [Page counter] for 
replacement procedure of consumables. 
Also see the Operator’s guide of the scanner for how to replace 
consumables. 

 

• An application is started automatically or a window appears to choose an application. 

Cause: 

Device event is activated. 

User response: 

See Chapter 6.3 “Events Tab” and select “Disable device events” or 
define the proper setting.