JVC GY-HM700CHE 사용자 설명서

* Default values are indicated in bold characters.

Off

For specifying whether to display the time code/user’s bit rate in the status display on the LCD 
monitor and viewfinder screens.
On

: Displays the time code or user’s bit rate. Whether time code or user’s bit rate is 

displayed is determined by the setting of the [TC DISPLAY] switch on the inner panel of 
the camera recorder’s LCD monitor.

Off

: Hides the time code or user’s bit rate.

Off

For specifying whether to display the audio level meter in the status display on the LCD monitor 
and viewfinder screens.
On

: Displays the audio level meter.

Off

: Hides the audio level meter.

Time

Capacity%

For setting the display of the status screen when a battery is loaded. The status screen is 
displayed on the LCD monitor and/or viewfinder.
The battery information appears only on the STATUS 1 Screen in Camera mode. (

Time

: Displays the remaining battery power in minutes. 

AminB

Capacity% : Displays the remaining battery power in percentage. 

A%B

Voltage

: Displays the current battery voltage in units of 0.1 V. 

AVB

● ATimeB display is disabled when an IDX battery is loaded. Even when ATimeB is selected, this 

is displayed as 

AVoltageB.

● When ATimeB or ACapacity%B is selected, the battery mark that appears before the value 

changes according to the remaining battery power.

: 12 % and below, 

: 13 % - 29 %, 

: 30 % - 59 %, 

: 60 % - 100 %

● Display changes to A

RES

B once the battery power falls below 12 %.

● When calibration of the battery is required, , A

CAL

B appears for 2 seconds after every 30 

seconds of the voltage display.

● CALIBRATION is a state that requires renewal of the battery power information. The battery is 

able to function as usual without calibration. However, calibration is recommended as correct 
information of the remaining power and time cannot be obtained otherwise. For more details, 
refer to the instruction manual of the Anton Bauer battery.

● The remaining battery power and remaining time are intended as reference values for the 

shooting duration.

YMD

For setting the date display sequence in the status display on the LCD monitor and viewfinder 
screens.
DMY

: Day/Month/Year

MDY

: Month/Day/Year

YMD

: Year/Month/Day

For setting the time display in the status display on the LCD monitor and viewfinder screens.
24hour : 24-hour display.
12hour : 12-hour display. (AM/PM)

DEG

For setting the shutter display in the status display on the LCD monitor and viewfinder screens.
DEG

: Displays the shutter speed in degrees in the same way as film cameras.

SEC

: Displays the shutter speed in seconds.

● ADEGB is selectable only when [Frame & Bit Rate] is set to A24p(SP)B, A24p(HQ)B, 

A25p(SP)B, or A25p(HQ)B. When [Frame & Bit Rate] is set to other values, the shutter display 
setting is fixed at 

ASECB and cannot be selected. (A Page 71)

● When a remote control is connected, the shutter display setting is fixed at ASECB regardless 

of the [Frame & Bit Rate] setting.

RES

2