Sony DVW-790WS/790WSP 사용자 설명서
8-20
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
8-16-3. Detail Frequency Adjustment
Note
Perform this adjustment, if necessary, to suit the custom-
er’s preferences.
er’s preferences.
Preparation
. On the setup menu, set as follows.
PAGE
: S12
*FUNCTION 1/2
ITEM
: DETAIL
→
ON
ITEM
: TEST OUT
→
ENC
. OUTPUT/DCC switch (inside panel)
→
CAM/ON
. Shoot a grayscale chart in the full underscanned monitor
frame.
Equipment
Equipment
: Waveform monitor
Test point
: TEST OUT connector
Setting point
:
1 Lens IRIS
Spec.
: A = 100
±
2 IRE (NTSC)
A = 700
±
14 mV (PAL)
. Select the line at the center white portion of the gray-
scale chart.
Adjustment Procedure
Equipment
: Waveform monitor
Test point
: TEST OUT connector
1.
On the setup menu, adjust as follows.
PAGE
PAGE
: S16
*LEVEL 1
ITEM
: DTL FREQ. (Factory setting: 0)
Spec.
: Set the desired width at the edge of
portion B.
Note
After this adjustment, be sure to perform Section 8-16-4
“H/V Ratio Adjustment”, and Section 8-16-5 “Detail Level
Adjustment”, in that order.
“H/V Ratio Adjustment”, and Section 8-16-5 “Detail Level
Adjustment”, in that order.
8-16. Detail Signal Adjustment
8-16-4. H/V Ratio Adjustment
Preparation
. On the setup menu, set as follows.
PAGE
: S12
*FUNCTION 1/2
ITEM
: DETAIL
→
ON
ITEM
: TEST OUT
→
ENC
. OUTPUT/DCC switch (inside panel)
→
CAM/ON
. Shoot a grayscale chart in the full underscanned monitor
frame.
Equipment
Equipment
: Waveform montior
Test point
: TEST OUT connector
Setting point
:
1Lens IRIS
Spec.
: A = 100
±
2 IRE (NTSC)
A = 700
±
14 mV (PAL)
Adjustment Procedure
Equipment
: Black and white monitor
Test point
: TEST OUT connector
1.
On the setup menu, adjust as follows.
PAGE
: S16
*LEVEL 1
ITEM
: H/V RATIO
Spec.
: Adjust so that the H and V detail amounts
which are added are equivalent.
A
H
V
A
B