Fujitsu MCE3064SS 사용자 설명서

7 - 8

C156-E097-01EN

(1)

Signal status value

Table 7.3 shows the correspondence between the input interface signal level at the receiving end
and its logic state.

Logic state

Signal level (at receiving end)

Single-ended type

True, "1", or asserted

Low (0.0 to 0.8 VDC)

False, "0", negated,, or released

High (2.0 to 5.25 VDC)

(2)

Signal driving method

Two driving methods are available: "OR-tied" type and "non-OR-tied" type as indicated in Table
7.4.

Signal status

Driving method

"OR-tied" type

"Non-OR-tied" type

False (*1)

No SCSI device drives a signal.
The signal becomes false when the
terminating resistor circuit is
biased.

A particular SCSI device drives the
signal false.  Otherwise,, no SCSI
device drives the signal.

True

An SCSI device drives the signal true.

*1  In this manual, the signal is said to be false if one of the following conditions is satisfied.

–  The signal is actually driven by an SCSI device to become false (non-OR-tied type).

–  No SCSI device is driving the signal (OR-tied type or non-OR-tied type).

In the interface operating sequence, the driving method of the BSY and RST signals which may
be driven by two or more SCSI devices simultaneously must be the "OR-tied" type.  Signals
other than BSY, RST, or DBP are not driven by more than one SCSI device.  Signals other than
BSY or RST can be driven by either the "OR-tied" type or "non-OR-tied" type.  The DBP signal
must not be driven false in the ARBITRATION phase.  For signals other than BSY or RST, both
"OR-tied" and "non-OR-tied" types can be mixed on the SCSI bus.