Fujitsu MCE3064SS 사용자 설명서
7 - 42
C156-E097-01EN
7.7
Bus Sequence
SCSI bus phases are switched in the specified sequence according to the command operation
executed in the TARG. After a TARG has asserted the BSY signal in the SELECTION or
RESELECTION phase, the bus phase sequence other than ATTENTION condition and RESET
condition is controlled by the TARG.
executed in the TARG. After a TARG has asserted the BSY signal in the SELECTION or
RESELECTION phase, the bus phase sequence other than ATTENTION condition and RESET
condition is controlled by the TARG.
All bus phases can be aborted through the RESET condition so that the BUS FREE phase is
always created. Also, any other phase can be followed by the BUS FREE phase.
always created. Also, any other phase can be followed by the BUS FREE phase.
Note:
The TARG can enter the BUS FREE phase in order to report an error condition. For details,
see Subsection 7.5.1.
see Subsection 7.5.1.
Figure 7.18 shows the allowable bus phase sequence applied to systems without the
ARBITRATION phase and sytems with the ARBITRATION phase. Figure 7.22 provides an
example of bus phase sequence during single command execution.
ARBITRATION phase and sytems with the ARBITRATION phase. Figure 7.22 provides an
example of bus phase sequence during single command execution.
IMPORTANT
Figure 7.21 shows the bus phase sequences applied to systems without
the ARBITRATION phase, systems with the ARBITRATION phase,
systems with the MESSAGE OUT phase, and systems without the
MESSAGE OUT phase. The generation of the ATTENTION condition
determines whether or not systems use the MESSAGE OUT phase. If
the ATTENTION condition is not generated, the TARG assumes that
the INIT is supporting only a COMMAND COMPLETE message and
the TARG operates so that it will not use other messages in the
subsequent command execution sequence. The ATN signal status is
ignored; therefore, the TARG does not enter the MESSAGE OUT
phase.
the ARBITRATION phase, systems with the ARBITRATION phase,
systems with the MESSAGE OUT phase, and systems without the
MESSAGE OUT phase. The generation of the ATTENTION condition
determines whether or not systems use the MESSAGE OUT phase. If
the ATTENTION condition is not generated, the TARG assumes that
the INIT is supporting only a COMMAND COMPLETE message and
the TARG operates so that it will not use other messages in the
subsequent command execution sequence. The ATN signal status is
ignored; therefore, the TARG does not enter the MESSAGE OUT
phase.