AT&T 7720 사용자 설명서

ANSWERING SYSTEM SET-UP

Setting Up Caller Specific Outgoing Announcements

Access the announcement directory by pressing the following key and
softkeys in sequence:

U, NEXT, DIRECTORY, ANS SYS, and then

OUTGOING.

Select

SETUP. The screen displays the number of the announcement

on the first line and shows

ENTER NUMBER: on the second line.

NOTE: If you have already entered three caller specific announcements,
you will need to delete one of them to record a new caller specific
announcement (see “Reviewing/Deleting Caller Specific Announcements”).

To enter a number, use the keypad and the digits will appear on the
display
— OR —
Select

OPTION to enter PRIVATE CALLER as the call type

— OR —
Select

OPTION twice to enter UNKNOWN CALLER as the call type.

Select

DONE when you see the entry you want displayed on the screen.

Select

RECORD. You will hear “Record at the tone,” followed by a

beep. Speak into the handset to record your announcement.
RECORDING shows on the display. Select STOP or press 5 when you
are done speaking.

The system will automatically play back your announcement for
review. Select

DONE to exit

— OR —
To set the announcement for Announce Only, go to Step 7.

If you want to set this announcement for Announce Only, continue with
the following steps.

After you hear your announcement played back, select

OPTION.

Select

NEXT until you see ANNC ONLY displayed in the lower right of

the screen.

Select

ANNC ONLY. *AO appears after the caller entry, and AO=OFF

replaces

ANNC ONLY in the lower right of the screen. The memory

match announcement is set for Announce Only.

10 To turn the Announce Only feature off, repeat Steps 7–9 above and

select

AO OFF when you get to Step 9.