GE 4 Series 사용자 설명서

Concord 4 Series Security Systems

To jump partitions using an access code:

1. From any hardwired touchpad, press

CODE

Touchpads display, “ENTER PARTITION” or “ENTER CMD.”

2. Press

the desired partition number (1 - 6)

The touchpad sounds one short beep if the jump was successful. One long beep means the

jump was not successful. Alphanumeric touchpads display the text in the newly entered parti-

tion.

3. Proceed to arm, disarm, or program as needed. The partition assignment reverts back if no

touchpad buttons are pressed for 10 seconds.

To jump partitions without using an access code:

1. From any hardwired touchpad, press

Touchpads display, “ENTER PARTITION” or “ENTER CMD.”

2. Press

the desired partition number (1 - 6)

The touchpad sounds one short beep if the jump was successful. One long beep means the

jump was not successful. Alphanumeric touchpads display the text in the newly entered parti-

tion.

3. Proceed to arm, disarm, or program as needed. The partition assignment reverts back if no

touchpad buttons are pressed for 10 seconds.

Arming and Disarming Another Partition

Any access code that can jump to another partition can control that partition. Once in the other

partition, you must use a valid code for arming and disarming that partition.

Programming Another Partition

Only System Master and Partition Master codes can be used for programming. Only one partition

can be programmed at a time. When one partition is in the programming mode, touchpads in the

other partition are locked out from any programming activity. However, arming and disarming

can continue.
Some partition-specific settings share resources, such as access codes and time schedules. For

example, if Partition 1 uses Regular User numbers 00 through 20, Partition 2 will not be able to

see or use those user numbers. The first Regular User number available for Partition 2 would be

21.
The allocation of time schedules works in much the same manner. There are 16 schedules that

can be used by any partition, but as soon as Partition 1 attaches a schedule to any event, that

schedule cannot be used by another partition, and vice versa.

Arming and Disarming Multiple Partitions at the Same Time

Note

Check with your installer to

identify which keychain

touchpads can arm/disarm

multiple partitions.

Your system may be set up to let you simultaneously arm and disarm more than one partition.

This can be done from system touchpads or keychain touchpads assigned to the associated parti-

tions.

To arm multiple partitions at the same time from a touchpad:

1. Press 2 or 3 on any touchpad assigned to one of the partitions you want to arm. The display

shows “ENTER CODE”.

2. Enter your Access Code. The display shows all the partitions that will be armed.
3. Press # to arm all displayed partitions.

Or,

Press the number of any partitions you don’t want armed (the partition numbers disappear

from the display), then press #.

To disarm multiple partitions at the same time from a touchpad:

1. Press 1 on any touchpad assigned to the partitions you want to arm. The display shows

“ENTER CODE”.

2. Enter your Access Code. The display shows all the partitions that will be disarmed.