Lorex Technology LH130 사용자 설명서
106
Appendix B: Connecting a PTZ Camera
Appendix B: Connecting a PTZ Camera
You can connect RS-485 PTZ cameras (not included) to the RS485 ports on the rear panel.
To connect a PTZ camera to the system:
1
Connect the Transmit+ (TX+) Cable to the + side of the RS485 port on the rear panel.
2
Connect the Transmit- (TX-) Cable to the - side of the RS485 port on the rear panel.
3
Connect the video cable to a BNC port.
Configuring PTZ Settings
Before you can use the PTZ controls, you must enter your camera’s PTZ protocol details
into the DVR.
into the DVR.
Prerequisite:
• Obtain the PTZ protocol details for your camera. Check your camera’s instruction manual for
details.
To enter PTZ camera settings in the DVR:
1
Right-click to open the Menu Bar and click the Main Menu button (
).
2
Click Device and select the PTZ tab.
BNC
TX+
TX-
8-channel model shown
Alarm block on 16-channel model
NOTE: Use a flat-head screwdriver
to loosen the screws above the
RS485 ports, then insert the cables
and tighten the screws to secure
to loosen the screws above the
RS485 ports, then insert the cables
and tighten the screws to secure